DEEBOT OZMO 920 replacement parts
5 parts that fit the DEEBOT OZMO 920, with the official SKU where one exists.
Support status changes the repair-or-replace math. See the full table →
COMPATIBLE PARTS
As an Amazon Associate, RoboFaults earns from qualifying purchases. Prices are shown on the retailer's site.
Side brushes — OZMO 920/950/T5, T8, N8 & T9+ series
ECOVACS groups these LiDAR generations into one accessory family — its own Buddy Kits list OZMO 920/950/T5/T8/N8 compatibility together. Clean the connector under each brush when swapping; debris there mimics a brush fault.
Check price on Amazon ↗
Main brush — OZMO 920/950/T5, T8, N8 & T9+ series
Release the brush cover tabs, lift the roller out and cut away wrapped hair before deciding it needs replacing — the official brushes-not-rotating fix clears the roller and both end caps first.
Check price on Amazon ↗
High-efficiency filters — OZMO 920/950/T5, T8, N8 & T9+ series
Official Buddy Kits ship three filters per kit for these series — ECOVACS expects filter swaps to outpace brush swaps. A clogged filter drops suction long before the motor complains.
Check price on Amazon ↗
Washable mopping pads — OZMO plate models
These models drag a flat microfiber pad on a velcro plate under the water reservoir. Wash pads after every mopping run and replace them once the fiber glazes over — a worn pad streaks instead of scrubbing.
Check price on Amazon ↗
Replacement battery — OZMO 920 (3200mAh)
The OZMO 920 uses the original 14.8V 3200mAh pack — not the physically different 5200mAh OZMO 950 battery. Power off before opening the compartment, never use a swollen, hot or leaking pack, and recycle the old battery.
Check price on Amazon ↗